Chapter 3: Working with Target Servers68Configure Scan Settings in VKC and AKCThe KX II and LX provide a port scanning feature that searches forselected targets and displays them in a slide show view, allowing you tomonitor up to 32 targets at one time. You can connect to targets or focuson a specific target as needed. Scans can include standard targets,blade servers, tiered Dominion devices, and KVM switch ports. Configurescan settings from either the Virtual KVM Client (VKC) or Active KVMClient (AKC). See Configure Scan Settings in VKC and AKC for moreinformation. See Scanning Ports. Use the Scan Settings tab to customizethe scan interval and default display options.To set scan settings:1. Click Tools > Options. The Options dialog appears.2. Select the Scan Settings tab.3. In the "Display Interval (10-255 sec):" field, specify the number ofseconds you want the target that is in focus to display in the center ofthe Port Scan window.4. In the "Interval Between Ports (10 - 255 sec):" field, specify theinterval at which the device should pause between ports.5. In the Display section, change the default display options for thethumbnail size and split orientation of the Port Scan window.6. Click OK.View OptionsView ToolbarYou can use the Virtual KVM client with or without the toolbar display.To toggle the display of the toolbar (on and off): Choose View > View Toolbar.View Status BarBy default, the status bar is displayed at the bottom of the target window.To hide the status bar: Click View > Status Bar to deselect it.To restore the status bar: Click View > Status Bar to select it.
