Commissioning91AAXISAXIS 20.1AXIS 20.2A CommissioningA.1 Mounting the universal drive shaft with shear pin protection to AXIS 20.2The machine AXIS 20.2 M EMC is equipped ex works and delivered with a driveshaft with shear pin protection.This section is not relevant for the machine version. See 8.3: Mounting the universal drive shaft at the machine, page 50.A.1.1 Mounting the universal drive shaft1. Check the installation position. The drive shaft end that is marked with a tractor symbol must point to thetractor.n CAUTIONMaterial damages due to unsuitable drive shaftThe machine is delivered with a drive shaft that is designed accordingto the device and performance.The use of incorrectly dimensioned or inadmissible drive shafts, forinstance without guard or suspension chain, may cause personalinjury or lead to damage to the tractor and/or the machine. Use universal drive shafts approved by the manufacturer only. Follow the directions in the operator’s manual of the universaldrive shaft manufacturer.NOTICEIf you want to mount a universal drive shaft with ratchet clutch, please proceedas described in chapter 8.3: Mounting the universal drive shaft at the machine,page 50.2. Remove the protective cap.3. Loosen the locking screw [1]of the universal drive shaftguard.4. Turn the universal driveshaft guard to the demount-ing position.5. Pull the universal drive shaftout.Figure 1: Loosen the universal drive shaftguard1AXIS 20.2KDRCQWEMC
