Maintenance and repairC148AXISAXIS 30.1, AXIS 40.1C Maintenance and repairC.1 SafetyMaintenance and service work involves additional hazards that do not occur dur-ing operation of the machine.For this reason, any maintenance and repair work is to be conducted with in-creased alertness at all times. Work particularly thoroughly and cautiously.Observe the following instructions in particular: Welding and work on the electrical and hydraulic systems is to be carried outby qualified technicians only. There is a risk of tipping when working at the lifted machine. Always securethe machine using suitable supports. Always use both eyebolts in the hopper for lifting the machine with hoistinggear. There is a risk of crushing and shearing at power-operated components(adjustment lever, metering slide). Make sure that there is no one in closeproximity to the moving parts during maintenance. Spare parts must at least comply with the technical standards specified by themanufacturer. This is assured only with original spare parts. Before starting any cleaning, maintenance, or repair work, and when trouble-shooting, switch off the tractor's engine and wait until all moving parts of themachine have come to a stop. By controlling the machine with an operating unit, additional risks and haz-ards due to externally operated components may arise.- Disconnect the power supply between the tractor and the machine.- Disconnect the power supply cable from the battery. ONLY an instructed and authorised workshop may carry out any repairwork.NOTICEPlease note the warnings in chapter 3: Safety, page 5.Take particular note of the instructions in the section 3.8: Maintenance andrepair, page 12.KDRCQWEMC
