Raven CR Series Operation Manual
Also see for CR7: ManualInstallation manualQuick start guideOperation manualInstallation guide
                                                                         | |
Contents
| 
8INSTALLATION1. Mount the antenna on the centerline of the tallest point of the vehicle (usually onthe top of the vehicle cabin) using the magnetic mount. Make sure that theantenna has a clear, 360° view of the sky. If the mounting location is non-magnetic, use a mounting plate to mount the antenna.2. Route the Power/GPS cable to the back of the field computer and connect it tothe Power/GPS port.3. Use the provided RAM mount arm to install the field computer inside the cab.4. For additional cabling and connection assistance, refer to the CR7 and CR12Installation Guide. Additional system diagrams are available on the Ravenwebsite.http://portal.ravenprecision.com/INITIAL SET UPWhen starting the system for the first time, a setup wizard will walk you through asetup process and, if desired, allow you to quickly begin creating guidance lines. Thissection covers the first time startup.IMPORTANT: Check all measurements before entering values into the field computer andenter all measurements as accurately as possible. Check that values enteredon the field computer are consistent with measurements.IMPORTANT: The CR12 startup wizard will ask for the cable harness type used with the fieldcomputer. The default option is 115-8000-064 and should only be used if thepart number of the cable harness connected to the CRX field computermatches. If using a different cable, select ”Other” from the drop-down. Ifneeded, the cable selection can be edited later in the GPS Information tab. |
Related manuals for Raven CR7
manualsdatabase
Your AI-powered manual search engine