24 ST70+ User Reference ManualDate & TimeThe Time & Date summary page shows the currentvalues applied to your ST70+ system.Note: If your display is not receiving GPS information, the Time& Date page is not displayed. In this case, proceed withthe Data units setup procedure below.Check the information, on the Time & Date summarypage, then press OK to display the Time & Datesetup menu.You can change certain date and time parameters. You can:• Select either dd/mm/yy or mm/dd/yy as the date format• Select either 12-hour (am/pm) or 24-hour as the time format.• Set the value of the time offset to give the required local time.If you want to change any Time & Date values, carry out the Setting date format,Setting time format and/or Setting local time procedure below, as appropriate.If you do not want to change any Time & Date values, proceed from Leaving date &time setup below.Setting date formatTo set the required date format:1. At the Time & Date setup menu, scroll to the Setdate format option, then press OK to displaythe Set date format page.2. Scroll to select the required Date Format, thenpress OK to save the format and return to theTime & Date summary page.3. Press OK to select the Time & Date setup menu.Setting time formatTo set the required time format:1. With the Time & Date setup menu displayed,scroll to select the Time Format option, thenpress OK to display the Set time format page.iD11149-1Press OK to continueTime & DateThese are your current settings.10 Time 11:01:03Date 14/06/07Time Offset -1 HrsTime Format 24-hourDate Format dd/mm/yyD11153-1Time & DateSet date formatPress OK to select10iD11154-1Press OK to acceptSet date formatUse < & > to adjust.CANCEL exits without saving.dd/mm/yy10D11155-1Time & DateSet time formatPress OK to select10