Raymarine ST70+ Installation Manual

Also see for ST70 Instrument: Installation guide Operating guide User reference guide User reference handbook Operating guide

Contents

Raymarine ST70+ Installation Manual Manual pdf 36 page image

26 ST70+ User Reference Manual• Wind speed to either knots or meters per second.• Heading to either magnetic or true.• Flow rate to either US gallons per hour, UK gallons per hour or liters per hour• Temperature to degrees Celsius or degrees Fahrenheit.• Pressure to pound per square inch or kilo Pascals.• Volume to either US gallons, UK gallons or liters• Number of engines to either 1, 2, 3, 4 or 5.• Number of batteries to either 1, 2, 3, 4 or 5.• Number of fuel tanks to either 1, 2, 3, 4 or 5.Press OK to see the second Units summary page, and if you want to return to the firstpage from the second, press CANCEL.Check the information on the Units summarypages, then with the second Units summary pagedisplayed, press OK to display the Select unitsmenu.If you want to change any data units, carry out theChanging units procedure below.If you do not want to change any data units,proceed from Leaving units setup below.Changing unitsTo change any data units:1. With the Select units menu displayed, scroll to select the type of data you want tochange, i.e. Speed, Depth, Distance, Wind Speed etc.2. Press OK to display the setup page for theunits you have selected.3. Scroll to select the required units.4. Press OK to save the units setting and return tothe first Units summary page.5. Press OK twice, to display the Select unitsmenu.6. If you want to change any other units, repeatsteps 1 to 5 of this procedure.Leaving units setup:When your data units are set as required:1. With the Select units menu displayed, scroll tothe Continue option.2. Press OK.Initial setup now ends.iD11161-1Select unitsWind Speed UnitsSelect units to change, using <or >.Press OK to selectiD11162-1Press OK to acceptWind Speed UnitsKTSSelect required units, using < or>. CANCEL exits without savingiD11160-1Select unitsContinueSelect units to change, using <or >.Press OK to select