6.22 Memory cards and chart cardsMicroSD memory cards can be used to back up /archive data (e.g. Waypoint, and Tracks). Oncedata is backed up to a memory card old data canbe deleted from the system, creating capacity fornew data. The archived data can be retrieved at anytime. Chart cards provide additional or upgradedcartography.It is recommended that your data is backed up to amemory card on a regular basis. Do NOT save datato a memory card containing cartography.Compatible cardsThe following types of MicroSD cards are compatiblewith your display:• Micro Secure Digital Standard-Capacity(MicroSDSC)• Micro Secure Digital High-Capacity (MicroSDHC)Note:• The maximum supported memory card capacityis 32 GB.• MicroSD cards must be formatted to use eitherthe FAT or FAT 32 file system format to enableuse with your MFD.Speed class ratingFor best performance it is recommended that youuse Class 10 or UHS (Ultra High Speed) classmemory cards.Chart cardsYour product is pre-loaded with electronic charts(worldwide base map). If you wish to use differentchart data, you can insert compatible chart cards intothe unit's memory card reader.Use branded chart cards and memory cardsWhen archiving data or creating an electronic chartcard, Raymarine recommends the use of qualitybranded memory cards. Some brands of memorycard may not work in your unit. Please contactcustomer support for a list of recommended cards.a6x and a7xInserting a memory card or chart card1. Open the card reader door, located on the frontright of the display.2. Insert the card, as shown in the diagram below,the card contacts should be facing UP. Do NOTforce the card. If the card does not fit easily intothe slot, check the orientation.D12828-13. Gently press the card all the way in to the cardslot, as shown in the diagram below. The card issecure when an audible click is heard.D12829-14. To prevent the ingress of water and consequentdamage, close the card reader door.Removing a memory card or chart cardFrom the homescreen:1. Select My Data.2. Select Eject Card.3. Open the card reader door, located on the frontright of the display.4. Push the edge of the card towards the unit, untilan audible click is heard.The card is released from the card slotmechanism, as shown in the following diagram:92 a Series / c Series / e Series installation instructions
