P36E-4 Zero Clearance Direct Vent Gas Fireplace38LOG SET INSTALLATIONRead the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they arereplaced. Broken logs can interfere with the pilot operation.The gas log kit (Part # 512-930) contains the following:a) 02-49 Rear Logb) 02-55 Middle Left Logc) 02-50 Front Left Logd) 02-53 Center Left Loge) 02-51 Front Bottom Logf) 02-54 Center Right Logg) 02-52 Middle Right Logh) 902-156 Embersi) 902-179/21 Vermiculitej) 946-669 Platinum Embers ( supplied w/packaged manual)4) Place Log 02-51 on the front right side of the burner. Pushthe back of the log against the 2 brackets with the notchon the bottom right side of the log fitting into the right sideof the grate.NotchBracketBracket3) Place Log 02-49 on the rear log support pins with the flatside to the back.02-4902-51NOTE: If installing the optional Brick Panels, install priorto log installation.1) Carefully remove the logs from the box and unwrap them.The logs are fragile, handle with care - do not force intoposition.2) Sprinkle the vermiculite around the firebox base.Vermiculite02-4902-51The "02" refer numbers (i.e. 02-49) aremolded into the rear of each log.INSTALLATION