Regency P48-2 Owners & Installation Manual

Also see for P48-2: Owners & installation manual

Contents

Regency® P48-2 Zero Clearance Direct Vent Gas Fireplace 29INSTALLATION28) Locate the ground lug at the receptical box,left of the unit.29) Connect one end of the supplied greenground wire to the lug with the nut andwasher from the kit.30) Install the 1/2" bushing to the heatshield.Groundwire fromkit32) Plug the DC spark generator wires to theDC Sparker.33) Connect the ground wire to the DC Sparkermounting bracket.35) Mount the heat shield to the DC Sparker.Secure into place with the velcro, which isprovided in the kit.Heat Shield31) Run the other end of the ground wire andDC spark generator wires through thebushing on the heat shield.37) Tie up the loose wire with the wire clip.Chain36) Find a location which is not too hot andis easy to reach for changing the battery.Note: It should be kept away from thechain.34) Install the supplied battery into the DCSparker Box by opening the batterycompartment.NOTE: The battery in the DC Sparker Boxwill need to be replaced annually.BatteryCompartment