Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace44CAUTION: Wear gloves whenremoving damaged or brokenglass.BAY GLASS REPLACEMENT1) Remove the door from the unit and place ona soft surface to prevent scratching.2) Remove the nuts holding the glass clips inplace and remove.3) Replace the glass. The glass must havegasketing around it.4) Reverse the previous steps, replace the glassclips and fasten with the nuts but do not overtighten, as this can break the glass.5) Replace door on the stove and check theseal.MAINTENANCEWARNING: Do not operate theappliance with the glass panelsremoved, cracked or broken.Replacement of the glass panelsshould be done by a licensed orqualified service person.DOOR GLASSYour Regency® fireplace is supplied with hightemperature 5mm-Ceramic glass. If your glassrequires cleaning, we recommend using anapproved glass cleaner available at all authorizeddealers. Do not use abrasive materials.CAUTION & WARNINGS:* Do not clean when the glass is hot.* The use of substitute glass will void all productwarranties.* Care must be taken to avoid breakage of theglass.* Do not strike or abuse the glass.* Do not operate this fireplace without theglass front or with a cracked or broken glassfront.* Wear gloves when removing damaged orbroken glass.* Replacement of the glass panel(s) should bedone by a licensed or qualified service person.GLASS REPLACEMENTIn the event that you break your glass by impact,purchase your replacement from an authorizedRegency® dealer only.Replacement glass is shipped already installedinto the door frame. Reinstall as per Glass DoorInstallation in "Standard Flush Door" section.INSTALLING VALVE1) Attach the valve to the valve bracket withthe 4 (m5x8 metric) screws provided.2) Reconnect the "gas out" flare fitting with an11/16" wrench.3) Reconnect the "gas out" flare nut with a13/16" wrench.4) Install piezo ignitor push button assemblyand reconnect wire.5) Reconnect the quick drop out thermocouplenut with a 9mm wrench.6) Reconnect the pilot tube nut with a 7/16"wrench.7) Scrape off the old gasket from the floor of thefirebox and from the valve tray assembly.8) Install a new gasket and reinstall the valvetray assembly.Note: Failure to install a new gasketmay severely affect the applianceperformance.9) Reinstall the 10 hold down screws.10) Hook up the 2 TP and 2 TH wires to theappropriate connections on the valve.11) Reinstall the two bottom deflectors and brickpanels.12) Install burner and grate assembly.13) Hook up the gas line and check for gasleaks with a soap and water solution or agas leak detector. (Do not use open flamefor leak testing.)14) Fire up the unit temporarily.15) Check the manifold pressure.16) Reinstall the logs and brick panels asneeded.17) Close the door and replace the louvers.18) Fire up the unit again and check for properflame appearance and glow on logs.