Regency U41 Owners & Installation Manual

Also see for U41: Owners & installation manual

Contents

Regency U41 Owners & Installation Manual Manual pdf 5 page image

5Regency U41-3 ULTIMATE Gas Fireplace InsertFireplace Trim Kit, Part # 610-940, is available.If the factory built fireplace height is toolow for your Insert, you may remove thesmoke shelf, baffle plate, and damperplate from the factory built fireplace ifremovable without cutting or torching,as long as these items are saved and arere-installed in the event that the Insert isremoved.INSTALLATION INTOZERO CLEARANCEFIREPLACESThe ULTIMATE Gas Inserts are only approvedfor installation into the ULTIMATE GasInsert Zero Clearance Fireplace Kit, mod-el # 660-900.BEFORE YOU STARTSafe installation and operation of this appliancerequires common sense, however, we arerequired by the Canadian Safety Standardsand ANSI Standards to make you aware of thefollowing:General Safety Information1) The appliance installation must conformwith local codes or in the absence of localcodes, with current CAN/CGA B149 (inCanada) or the current National Fuel GasCode ANSI Z223.1. This appliance MUST beinstalled by a qualified gas fitter technicianonly.2) Installation and repair should be doneby a qualified service person.3) The appliance should be inspected beforeuse and at least annually by a professionalservice person. More frequent cleaningmay be required due to excessive lint fromcarpeting, bedding material, etc. It is imper-ative that control compartments, burnersand circulating air passageways of theappliance be kept clean and free fromexcessive lint from carpeting.4) See general construction and assemblyinstructions. This appliance may only beinstalled in a vented, non-combustible fire-place. The appliance and vent should beenclosed when installed in or passingthrough a living area, where children maycome in contact with it.5) This appliance is Listed for bedroom instal-lations when used with a Listed MillivoltIMPORTANT:SAVE THESEINSTRUCTIONSThe Regency Gas Fireplace must be installedin accordance with these instructions. Care-fully read all the instructions in this manual first.Consult the building authority having jurisdic-tion to determine the need for a permit prior tostarting the installation.Note: Failure to follow these instruc-tions could cause a malfunction ofthe heater which could result indeath, serious bodily injury, and/or property damage. Failure tofollow these instructions may alsovoid your fire insurance and/orwarranty.FOR YOUR SAFETYThis appliance requires air for proper combus-tion. Always provide adequate combustionand ventilation air. Follow instructions andinformation in the current CAN/CGA B149 (inCanada) or the current National Fuel Gas CodeANSI Z223.1 (in the USA), regarding require-ments for combustion and ventilation air.GAS PIPE TESTINGThe appliance must be isolated from the gassupply piping system by closing its individualmanual shutoff valve during any pressuretesting of the gas supply piping system at testpressures equal to or less than 1/2 psig. (3.45kPa).SPECIFICATIONSFuel: Natural gas or PropaneElectrical: 120V A.C. system.Fan/Blower: Variable speed, 125/75 CFM.Log Sets: Ceramic fiber, 3 per set.Vent System: Listed minimum 4" B-Vent orlisted double thicknessaluminium flex liner.INSTALLATION INTO AFACTORY BUILTFIREPLACEThe ULTIMATE Gas Inserts have been testedand approved to be vented into any approvedFactory Built Fireplace that will allow the Insertto physically fit into the firebox. A Factory BuiltINSTALLATIONThermostat. Some areas may have furtherrequirements, check local codes beforeinstallation.6) This unit is not approved for installation intoa mobile home.7) Always connect this fireplace to a chimneyand vent to the outside of the buildingenvelope. Never vent to another room orinside a building. Make sure that the vent isproperly sized and is of adequate height toprovide the proper draft.8) Inspect the venting system annually forblockage and any signs of deterioration.9) Any safety glass removed for servicingmust be replaced prior to operating theappliance.10) To prevent injury, do not allow anyone whois unfamiliar with the operation to use thefireplace.11) Due to high temperatures, the applianceshould be located out of high traffic areasand away from furniture and draperies.Children and adults should be alerted to thehazards of high surface temperatures,especially the fireplace glass and gold trims,and should stay away to avoid burns orclothing ignition. Young children should becarefully supervised when they are in thesame room as the appliance. Clothing orother flammable material should not be placedon or near the appliance.12) WARNING: Failure to position the partsin accordance with the diagrams inthis manual or failure to use only partsspecifically approved with this appli-ance may result in property damageor personal injury.13) WARNING: Operation of this appliancewhen not connected to a properly installedand maintained venting system or tamper-ing with the blocked vent shut-off systemcan result in carbon monoxide (CO) poison-ing and possible death.14) This appliance needs fresh air for safeoperation and must be installed so there areprovisions for adequate combustion andventilation air.MATERIALSREQUIREDNo electrical power supply is required for thegas control to operate. A 120 Volt AC powerEmissions from burning wood or gas couldcontain chemicals known to the State ofCalifornia to cause cancer, birth defects orother reproductive harm.