Regency U41 Owners & Installation Manual

Also see for U41: Owners & installation manual

Contents

Regency U41 Owners & Installation Manual Manual pdf 6 page image

6 Regency U41-3 ULTIMATE Gas Fireplace Insertcord is hooked up to the fan switch and blower.Plug 3 wire cord into a suitable receptacle. Donot cut the ground terminal off under anycircumstances.When connected with 120 volts, the appliancemust be electrically grounded in accordancewith local codes, with a current version of CSAC22.1 (in Canada) or in the absence of localcodes, with the National Electrical Code ANSI/NFPA 70-1987.Note: This unit is equipped with a heatsensor thermodisc which willprevent the blower from operat-ing until the unit reaches the cor-rect temperature.INSTALLATIONCHECKLISTThe Regency Gas Insert is installed as listedbelow.1) Unit Location - check Clearances to Com-bustibles on pages 6 and 7.2) Make the gas connections and electricalconnection for fan and vent spill switch.See page 8.3) Install the flue or liner to the sliding drafthood. See page 8.4) Install Venting, page 8. Slide the unit into thefireplace and level. Attach draft hood to theinsert.5) Test gas pressure, page 9. Check aeration,page 9.6) Test for flue spillage, page 9.7) Assemble and install the faceplate and trim.See page 10.8) Install the log set. See page 11.9) Install Doors. See page 11.10) Install Optional Remote Control, and Op-tional Wall Thermostat, page 12.11) Explain controls to the homeowner.12) Final check: Before leaving this unit withthe customer, the installer must ensure thatthe appliance is firing correctly. This in-cludes:a) Clocking the appliance to ensure thecorrect firing rate.b) Adjusting the primary air, if required,to ensure that the flame does notcarbon. See page 9.c) Ensuring that the appliance is vent-ing correctly. See page 8.INSTALLATIONCLEARANCESIGJHADBEFCTop ViewClearances to CombustiblesFrom UnitSides A 7.5" / 190 mmCeiling B 35" / 890 mmMantel C(My) 11 / 280 mmFrom SurroundSides D 2" / 50 mmCeiling E 25.5" / 650 mmMantel F 3" / 75 mmMin. Alcove Width J 48" / 1120 mmMantel Depth G(Mx) 7.5" / 190 mmFacing (Mantel Leg)Side* K 1" / 25 mmTop L 1" / 25 mmMinimum Fireplace ClearancesThe minimum fireplace clearances for the Re-gency gas fireplace insert are shown in thefollowing diagrams:*Max. width of 1" at 1" from surround, calculatedepth at 45o as shown in the diagram.