Safeline SL6+ Manual
Also see for SL6+: ManualManualQuick guide
                                            | |
Contents
| 
164455310006E4455310006E4455310006E4455310006E4455310006E4455310006E4455310006E4455310006E4455310004455310004455310006E6E6E6E6E4455310006E4455310006ECOPYRIGHT SAFELINE AB 2011WWW.SAFELINE.SE SL6 R1.12EN SL6+ v.3.04StartupLED 1LED 2LED 3ResetCOLOUR CODE LED1 2 3GSM SIGNALSTRENGTH3 green = 100 %1 yellow, 2 green = 85 %2 yellow, 1 green = 70 %3 yellow = 55 %1 red, 2 yellow* = 30 %2 red, 1 yellow = 15 %3 red = 0 %*Minimum signal strength for using GSM interface.LED IndicationFront PanelContinuous green Mains power supply OKFlashing red (400/400 ms) Battery operated, with power to the emergency light.Continuous red Battery operated, no power to the emergency light.LED 1 indicates the power supply statusLight off No active alarm/battery OK.Rapidly flashing yellow Active alarm not reset.(200/200 ms)Flashing red (400/400 ms) Battery check in progress.Continuous red Battery test failure/no battery connected.LED 2 indicates active alarm and battery conditionFlashing green (100/100 ms) Fire mode activated.Flashing green (400/400 ms) Call connection in progress.Slowly flashing green Telephone line connected.(200/4600 ms) GSM network OK.Continuous green Call connected.Flashing yellow (100/100 ms) Incoming call.Flashing red (400/400 ms) No telephone line connected.Searching for GSM network.Continuous red No SIM card (when using GSM).LED 3 indicates the phone line's statusPress for 3 sec Show GSM signal strength (see table below).Press 3 times Start a self test (battery + bus initialization).Press once Resets an active alarm. Aborts calls in progress.Press 5 sec - release SL6+ turns off. NOTE! Refers to battery powered only!Reset button |
Related manuals for Safeline SL6+
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine