Safety 1st Grow and Go 3-in-1 Instructions Manual

14Reclining Child Restraint136. Check Harness TightnessTry to pinch the harness at theshoulders vertically between indexfinger and thumb as shown.If your fingers slip off, theharness is tight enough.If you can pinch the harnessstrap, tighten more.5. Position Chest ClipThe chest clip must be placed atmid-chest (even with armpits) andaway from the child’s neck.WARNINGS: Failure to fasten and tighten the harnesssystem correctly may allow the child to be ejected fromthe child restraint in a crash or sudden stop causingserious injury or death.Do not mistake comfort for safety. Harness system mustbe snugly adjusted.Snug harness straps should not allow any slack. They lay ina relatively straight line without sagging. They do not presson the child’s flesh or push the child’s body into an unnaturalposition.To Remove Child From Child Restraint:1. Loosen Harness Strap2. Unbuckle Harness3. Release Chest Clip4. Remove ChildTo recline, pull out on recline handleand push top of child restraint back.For upright, pull out on reclinehandle and pull top of child restraintforward.This child restraint has 3 positions:Rear Facing - 2 and 3For children who cannot sit upunassisted, the level line on shellMUST be parallel with the ground.For children who can sit upunassisted, you may rotate the childrestraint to be more upright.Forward Facing - 1 UprightBooster Seat - 1 Upright321NOTE: When forward facing, the reclined positions are to beused only to install the child restraint and booster seat flushagainst the vehicle seat back. Vehicle seat back must beupright.4358-6653 Grow and Go 3 in 1.indd 19-204358-6653 Grow and Go 3 in 1.indd 19-20 4/15/15 8:47 AM4/15/15 8:47 AM