Adjusting Headrest/Harness Height76. Insert Buckle’s MetalRetainer into SlotClosest to ChildBuckle MUST face out. You MUSTuse the 1st or 2nd buckle slotswhen child restraint is used rearfacing. Any slot can be used whenforward facing.1237. Reach Under the SeatBetween Base and Shelland Through ReclineHandlePull metal retainer completelythrough pad and shell.8. Check BucklePull up on buckle to make sure itis secured. The buckle MUST notpull out.You MUST always use thebuckle cover. Slide end ofbuckle cover into buckle slot inpad.WARNING: Failure to place buckle’s metal retainercompletely through pad and shell can result in seriousinjury or death.WARNINGS: Verify frequently that the harness height iscorrect for your child’s size. It is very important to read,understand, and follow all instructions and warnings.Do not use this child restraint rear facing unlessthe top of your child’s head is at least 1 in. (2.5cm) below the top of the child restraint’s headrest.Do not use this child restraint forward facing if thethe tops of your child’s ears are above the top ofthe child restraint’s headrest in its highestposition.Failure to follow these steps can result in serious injuryor death.81. Fully Loosen HarnessStrapsPush down on harness releaselever (under flap on front of seatpad) while pulling out on harnessstraps as shown.2. To Adjust Headrest/Harness HeightRotate headrest/harnessadjustment levers inward.Move the headrest up or down tothe proper height for your child.See page 5.Release it into slot to lock. Makesure it is securely locked intoplace.5. From Top of Seat,Pull Buckle and BuckleCover Out of Shell andPad4358-6653 Grow and Go 3 in 1.indd 13-144358-6653 Grow and Go 3 in 1.indd 13-14 4/15/15 8:47 AM4/15/15 8:47 AM