How Does Your Child Fit? Changing Position of Buckle652. Fully Recline the ChildRestraintPull out on recline handle and pushtop of child restraint back.1. Unbuckle HarnessPress in towards the top of the redbutton.Pull buckle tongues out.3. Locate Buckle’s MetalRetainerReach under the seat between thebase and shell and through therecline handle.4. Rotate Metal Retainerand Push It Up ThroughShell and PadREAR FACINGFORWARD FACINGStart in the 1st slot and adjust outward as yourchild grows. Buckle should be used in the slotclosest to your child. 1st or 2nd slot MUST be used.Start in the 1st slot and adjust outward as yourchild grows. Buckle should be used in the slotclosest to your child. Any slot can be used.Always choose the shoulder harness slot that isclosest to your child’s shoulder height. Harnessstrap MUST be at or slightly below shoulders.If the lower shoulder harness slots are above thechild’s shoulders with the headrest in the lowestposition, do not use this child restraint.To make changes to the buckle, see pages 6-7.To adjust headrest/harness height, see page 8.To make adjustments for smaller infants, see pages 9-11.Use the guidelines below to determine if the buckle and harnessstrap are in the right place for your child.12123Always choose the shoulder harness slot that isclosest to your child’s shoulder height. Harnessstrap MUST be at or slightly above shoulders.If the upper shoulder harness slots are below thechild’s shoulders with the headrest in the highestposition and the child weighs at least 40 lb (18 kg) and is at least 4years old, you must convert the child restraint to a booster seat.continued on next page4358-6653 Grow and Go 3 in 1.indd 11-124358-6653 Grow and Go 3 in 1.indd 11-12 4/15/15 8:47 AM4/15/15 8:47 AM