48Vehicle Belt InstallationWARNINGS: Do not use LATCH along with thevehicle lap or lap/shoulder belt. StoreLATCH as shown when using vehiclebelts.Check vehicle belt before each use.Use only if the belt can be tightenedproperly and securely.Failure to follow these warnings can result in serious injuryor death.1. Place Child RestraintForward Facing FlushAgainst Vehicle Seat BackDo not use any recline positionsexcept to make the child restraintflush against the vehicle seat back.Vehicle seat back must be upright.2. Loosely Attach TetherHookConsult vehicle owner’s manual forspecific location.473. Route Vehicle Lap orLap/Shoulder BeltThrough Forward-Facing Belt PathReview pages 29-30 and your vehicleowner’s manual to determine whatkind of vehicle belts you have.Do not twist belt. Buckle vehiclebelt.5. Tighten TetherWith knee still in child restraint,push firmly on the back of the seatand tighten tether strap.4. Tighten BeltPlace knee in child restraint.Firmly push down while pullingshoulder belt or free end of lap belt totighten.6. Check Belt TightnessHold child restraint at the belt pathwith your weakest hand.Push and pull from side to side.If it moves more than 1 in. (2.5 cm),try reinstalling the child restraint, tryanother seating location, or try usingthe LATCH belt instead if available.Safety Tips:Make sure harness and buckle fit your child correctly beforeinstalling the child restraint. See pages 3-5.Experts agree that children should remain rear facing as longas possible. In this child restraint, your child can remain rearfacing up to 40 lb (18 kg) and up to 40 in. (101.6 cm).4358-6653 Grow and Go 3 in 1.indd 53-544358-6653 Grow and Go 3 in 1.indd 53-54 4/15/15 8:48 AM4/15/15 8:48 AM