Safety 1st Grow and Go 3-in-1 Instructions Manual

Harness System Adjustments forSmaller Infants107. Fully Loosen HarnessStrapsPush down on harness release lever(under flap on front of seat pad) whilepulling out on harness straps as shown.6. Adjust the Headrest to theLowest PositionThe headrest MUST be in the lowestposition.8. From Back, Remove HarnessStrap Loops From SplitterPlate9. Pull Harness Straps Out ofUpper Shoulder HarnessSlots10. Pull Body Pillow ForwardAway from SeatThread harness straps through slots inpillow.You MUST use the body pillow.continued on next page91. With Buckle in the 1st Slot,Fully Recline the SeatIf you need to move the buckle to the 1stslot, see page 6.5. Replace Pad and CheckBucklePull up on buckle to make sure it issecured. The buckle MUST not pull out.You MUST always use the bucklecover.2. Lift Pad Off of Front ofChild Restraint4. From Top of Seat, Lay theMetal Retainer Flat Againstthe Shell As Shown3. From Bottom of Seat, PullMetal Retainer Down andPush It Up into Middle SlotAs ShownWhen using the lower shoulder harness slots for smaller infants,you MUST use the body pillow and the headrest MUST be in thelowest position.4358-6653 Grow and Go 3 in 1.indd 15-164358-6653 Grow and Go 3 in 1.indd 15-16 4/15/15 8:47 AM4/15/15 8:47 AM