Safety 1st Grow and Go Air Instructions Manual

Safety 1st Grow and Go Air Instructions Manual Manual pdf 31 page image

55 56Using a Locking ClipYou will rarely need to use a locking clip except in some oldervehicles. Built-in child restraint locking systems have been requiredin vehicles since 1996, and many vehicles had these features evenearlier. Review pages 30-31 and your vehicle owner’s manual todetermine if your vehicle belts require a locking clip.If you need a locking clip immediately, they are likely available at anauto dealership, an auto store, or where you purchased this childrestraint. You can also email us at consumer@djgusa.com or callus at 1-800-544-1108 for one.A locking clip will not fix all types of seat belt problems. You MUSThave a lap and shoulder belt to use a locking clip. Do not use thelocking clip when using this seat as a booster seat.For Rear Facing installation, follow pages 39-41 Warnings andSteps 1-5 before starting locking clip installation.For Forward Facing installation, follow pages 49-51 Warningsand Steps 1-4 before starting locking clip installation.1. Determine Locking Clip PositionGrasp both vehicle belts together justbehind the latch plate to mark theposition for locking clip.Unbuckle the belt.NOTE: If the latch plate ends up justat the belt path opening so youcannot grasp the vehicle belt at the latch plate, grasp the vehiclebelts on the opposite side of the child restraint, as close to thelatch plate as possible.2. Attach Locking ClipThread both portions of the vehiclebelt onto the locking clip, as closeto the latch plate as possible.3. Position Locking ClipIt should be about 1 in. (2.5 cm)from vehicle belt’s latch plate.1 in.(2.5 cm)4. Rebuckle Vehicle Belt5. Check Belt TightnessHold child restraint at the belt pathwith your weakest hand.Push and pull from side to side.If it moves more than 1 in. (2.5 cm),try reinstalling the child restraint ortry another seating location.When installed rear facing,recheck the level line.When installed forward facing,make sure to tighten the tetherstrap.Remove the locking clip whenthe seat belt is not being usedwith a child restraint.4358-6835 Grow and Go Air.indd 61-624358-6835 Grow and Go Air.indd 61-62 10/29/15 3:34 PM10/29/15 3:34 PM

/ 34

Related manuals for Safety 1st EverFit