How Does Your Child Fit? Changing Position of Buckle652. Fully Recline the ChildRestraintPull out on recline handle and pushtop of child restraint back.1. Unbuckle HarnessPress in towards the top of the redbutton.Pull buckle tongues out.3. Locate Buckle’s MetalRetainerReach under the seat between thebase and shell and through therecline handle.4. Rotate Metal Retainerand Push It Up ThroughShell and PadREAR FACINGFORWARD FACINGStart in the 1st slot and adjust outward as yourchild grows. Buckle should be used in the slotclosest to your child. The buckle should be notunderneath or behind your child. 1st or 2nd slotMUST be used.Always choose the shoulder harness slots that areclosest to your child’s shoulder height. Harnessstrap MUST be at or slightly below shoulders.If the lower shoulder harness slots for smallerinfants are above the child’s shoulders with theheadrest in the lowest position, do not use thischild restraint.Start in the 1st slot and adjust outward as yourchild grows. Buckle should be used in the slotclosest to your child. The buckle should not beunderneath or behind your child. Any slot can beused.To change buckle position, see pages 6-7.To adjust headrest/harness height, see page 8.To make adjustments for smaller infants, see pages 9-11.Use the guidelines below to determine if the buckle and harnessstrap are in the right place for your child.12123Always choose the shoulder harness slots that areclosest to your child’s shoulder height. Harnessstrap MUST be at or slightly above shoulders.If the upper shoulder harness slots are below thechild’s shoulders with the headrest in the highestposition and the child weighs at least 40 lb (18 kg) and is at least 4years old, you must convert the child restraint to a booster seat.continued on next page4358-6835 Grow and Go Air.indd 11-124358-6835 Grow and Go Air.indd 11-12 10/29/15 3:33 PM10/29/15 3:33 PM