Securing Child in Child Restraint1112. From the Back, PullHarness Straps ThroughShellHarness straps MUST be in shoulderharness slots BELOW the metal bar asshown. DO NOT twist harness straps.13. Attach 2nd Harness StrapLoops to Splitter Plate AsShownSewn ends of the harness strap loopsMUST face towards you.DO NOT twist harness straps or harnessadjustment strap.Make sure the same harness strap loopsare fitted COMPLETELY ON both sidesof the splitter plate.Replace headrest pad around bottomof headrest.sewnend121. Place Child in ChildRestraintThe child’s bottom and back shouldbe flat against the child restraint.Position harness strap over child’sshoulders and upper thighs.3. Close Chest ClipInsert right half of chest clip intoleft half and snap together.2. Buckle HarnessPush buckle tongues into buckleuntil you hear them “click.”Pull up on harness strap to makesure buckle is locked.4. Tighten HarnessPull on harness adjustment strapto tighten harness snugly.continued on next pageCorrectWARNINGS: Harness system must be installed correctly.The harness strap must be returned to the upper shoulderharness slots as your child grows.Failure to follow these steps can result in serious injury ordeath.11. Pull Bottom of HeadrestPad Off of HeadrestThread harness straps through slots inheadrest pad.Thread harness straps through lowershoulder harness slots in headrest andthrough the slots in seat back (shell).4358-6835 Grow and Go Air.indd 17-184358-6835 Grow and Go Air.indd 17-18 10/29/15 3:33 PM10/29/15 3:33 PM