Regulatory information1205. AppendixThis equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the dealer or experienced radio TV technician for help.Change or modifications not expressly approved by the manufacturerresponsible for compliance could void the user's authority to operate theequipment.Canadian radio interference regulationsThis digital apparatus does not exceed the Class B limits for radio noiseemissions from digital apparatus as set out in the interference-causingequipment standard entitled “Digital Apparatus”, ICES-003 of the Industry andScience Canada.Cet appareil numérique respecte les limites de bruits radioélectriquesapplicables aux appareils numériques de Classe B prescrites dans la norme sur lematériel brouilleur: “Appareils Numériques”, ICES-003 édictée par l’Industrie etSciences Canada.13United States of AmericaFederal Communications Commission (FCC)Intentional emitter per FCC Part 15Low power, Radio LAN devices (radio frequency (RF) wireless communicationdevices), operating in the 2.4 GHz/5 GHz Band, may be present (embedded) inyour printer system. This section is only applicable if these devices are present.Refer to the system label to verify the presence of wireless devices.Wireless devices that may be in your system are only qualified for use in theUnited States of America if an FCC ID number is on the system label.
