Wireless network setup1732. Using a Network-Connected Machine8 The window showing the wireless network setting appears. Check thesettings and click Next.Before entering the IP address for the machine, you must know thecomputer’s network configuration information. If the computer’s networkconfiguration is set to DHCP, the wireless network setting should also beDHCP. Likewise, if the computer’s network configuration is set to Static, thewireless network setting should also be Static.If your computer is set to DHCP and you want to use the Static wirelessnetwork setting, you must contact the network administrator to get thestatic IP address.• For the DHCP methodIf the IP address assignment method is DHCP, check if DHCP is shown inthe Wireless Network Setting Confirm window. If it shows Static, clickChange TCP/IP to change the assignment method to Receive IPaddress automatically (DHCP).• For the Static methodIf the IP address assignment method is Static, check if Static is shown inthe Wireless Network Setting Confirm window. If it shows DHCP, clickChange TCP/IP to enter the IP address and other network configurationvalues for the machine.For example,If the computer’s network information is as shown follows:- IP address: 169.254.133.42- Subnet Mask: 255.255.0.0Then, the machine’s network information should be as below:- IP address: 169.254.133.43- Subnet Mask: 255.255.0.0 (Use the computer’s subnet mask.)- Gateway: 169.254.133.19 The Wireless Network Setting Complete window appears. Click Next.10 When the wireless network settings are completed, disconnect the USBcable between the computer and machine. Click Next.11 Follow the instructions in the installation window.
