Samsung DCS-408 System Administration Manual

Also see for DCS-408: Programming manual Programming manual User guide Installation manual Installation manual

Contents

Samsung System Administration GuideDCS-408 & 408i November 200118PROGRAM KEYSVOLUME UP & DOWN - Used to scroll through options.KEYPAD - Used to enter selections.SOFT KEYS - Move cursor left and right.SPEAKER - Used to store data and advance to next program.HOLD - Used to clear previous entry.B inserts a flash (“F”).C inserts a pause (“P”).D is used for pulse-to-tone conversion (“C”). If your system uses rotary (or pulse) dial-ling C.O. lines, pressing D while entering a speed dial number causes all subsequentdigits to be sent as DTMF tones.E is used to hide digits. You may want to hide some phone numbers so that they willnot show in the display when you dial the speed dial number during normal use. Whenyou are programming the phone number, press E before entering the digits you wantto hide. The symbol “[” is displayed. All subsequent digits will be displayed as “*” whenthe speed dial number is dialled. If you want some digits to display, press E again (“]”is displayed) before entering these digits.For example: if you program a speed dial number with the phone number 9-[0121]728765, when you later dial this speed dial number the display will show“✼✼✼✼728765”.Note: When programming an outside number, enter the access code (e.g. 9 or 0) before youpress E to hide any digits.F is used to enter the program which allows you to assign a name to the speed dialnumber you are programming. (Alternatively, you can program speed dial numbersfirst—as described here—then close the program and open the program to assignnames for the numbers you have set up.)Use the HOLD key to clear a speed dial number and/or name.ACTION DISPLAY1. Open customer programming and select 7052. Enter the speed dial number (e.g., 505)ORPress UP or DOWN to select and press the right soft keyto move the cursor3. Enter the access code ( e.g., 9 - the system automaticallyinserts a dash) followed by the phone number to be dialled(up to 24 digits)If you enter a wrong number, either press HOLD to clear theentire entry or use the DOWN key to move the cursor back4. Press the F key to to enter a name for this speed dial (seestep 3 of Program System Speed Dial Names)ORPress right soft key to return to step 2ORPress TRSF to store and exit programmingSYS SPEED DIAL500:SYS SPEED DIAL505:_SYS SPEED DIAL505:9-121223456789SYS SPEED NAME505: