Samsung DVM PLUS III Technical Data Book

Also see for DVM PLUS III: Technical data book Installation manual

Contents

Control SystemsV-1811 Individual control systemPCB DescriptionNo. Name DescriptionOption switches It is possible to set additional functionsfor wired remote controller.Software upgrade connector It is used to upgrade the micro-controller’s software.Communication & Power connector - Red, blue wire : Connection to indoor unit (F3/F4).- Orange, yellow wire :Connection to indoor unit (V1/V2).1231-3. Wired remote controller2) MWR-WS00(3) Description of buttons and functions(4) Additional functions123Tracking functionIf an additional indoor unit is connected to the wired remote controller,Function If a connected indoor unit is deleted.If wired remote controller is replaced.it is compulsory to carry out Tracking in the wired remote controller for indoor units.Press both Set button and Cancel button on the wired remote controller for 5 seconds.Then LCD backlight is turned on again and the temperature display is shown like below.At this time, there is no change in the operation status of the indoor unit.Control123Switch No.SW 1SW 2SW 3SW 4SW 5SW 6SW 7SW 8OFFFor cooling and heating modelAble to use both wireless remote controller and wired remotecontroller for indoor unit control.If two wired remote controllers are used to control 1 indoorunit (group), it is set as a master wired remote controller.Temperature display in Celsius (°C).Use the temperature sensor in the indoor unit for indoor unitcontrol.No functionNo functionService mode monitoringONFor cooling model only (If the operation mode is selected,heating operation display is skipped.)Unable to use wireless remote controller.If two wired remote controllers are used to control 1 indoorunit (group), it is set as a Slave wired remote controller.Temperature display in Fahrenheit (°F).Use the temperature sensor in the wired remote controller forindoor unit control.Use the average value of temperature sensors of wired remotecontroller and indoor unit for indoor unit control.No functionService mode settingAble to set an additional function for wired remote controllerwith the 8 option switches on the PCB of wired remote controller.❈ Default switch settings are all OFF.❈ Tracking is underway.Function keysOption switch05-1_control systems(002~045) 3/15/08 4:09 Page 18