10.3 4 Replace the control board cover.5 Reconnect the power cord and turn the printer on.NoteYou can also configure the network parameters on the controlpanel; see the next column.Configuring the wireless network parametersAfter installing the wireless network card, you must configure theappropriate network parameters to use your printer in a wirelessnetwork. To do this, you can use both control panel and SyncThru WebService, an embedded web site of your printer. This section gives youbasic information on 802.11b/g network parameters which can beconfigured from the control panel.Configuring basic network settingsYou can configure basic wireless settings, such as SSID, OperationMode, and channels. You can retrieve basic settings by selecting awireless network or manually configure them as you need.1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the scroll buttons until Wireless appears and press OK.3 Press OK when WLAN Basic appears.4 Press the scroll buttons to select the setup method you want andpress OK.• Search List: The wireless network interface card on your printersearches for wireless networks in the area and shows the results.• Custom: You can configure the wireless settings according toyour needs.5 If you selected Search List, press the scroll buttons to select anetwork and press OK.If you selected Custom, set each network options:• Edit SSID: Enter the SSID, the name that identifies a wirelessnetwork. SSID is case-sensitive so you need to enter it.• Operation Mode: Select the type of wireless connections.In Ad-Hoc mode, wireless cards communicate directly each other.In Infrastructure mode, network cards communicate with eachother through an access point, which allows both wireless andcabled cards to send files to the printer. If you select Auto, theprinter selects the operation mode automatically, according to thenetwork cable’s connection each time it boots up.NoteIn Ad-Hoc mode, even if the network cable is connected,your printer will use the wireless interface.• Channel: This option is available only in the Ad-Hoc mode. Inmost cases, you will not need to change this setting. The printerwill scan all available channels for the specified network and willadapt its channel to the one detected.6 When you have finished, press Stop to return to Standby mode.
