4.3 < Network setup(ML-3471ND only)>Configuring EtherTalkEtherTalk is AppleTalk used in an Ethernet network. This protocol iswidely used in Macintosh network environments. To use EtherTalk, takethe following step:1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the scroll buttons until EtherTalk appears and press OK.3 Press the scroll buttons until On appears and press OK.4 Press Stop to return to Standby mode.Setting Ethernet speedYou can select the communication speed for Ethernet connections.1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the scroll buttons until Ethernet Speed appears and pressOK.3 Press the scroll buttons until the speed you want appears andpress OK.4 Press Stop to return to Standby mode.Restoring the network configurationYou can return the network configuration to its default settings.1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the scroll buttons until Clear Setting appears and press OK.3 Press OK when Yes appears to restore the network configuration.4 Power the printer off and back on.Printing a network configuration pageThe network configuration page shows how the network interface cardon your printer is configured.1 Press Menu until Network appears on the bottom line of thedisplay and press OK.2 Press the scroll buttons until Network Info appears and press OK.3 Press OK when Yes appears.The network configuration page prints out.
