x Users ManualIf necessary, the user should consult the dealer or an experienced radio/televisiontechnician for additional suggestions. The user may find the following booklet helpful:“Something About Interference.” This is available at FCC local regional offices. Ourcompany is not responsible for any radio or television interference caused byunauthorized modifications of this equipment or the substitution or attachment ofconnecting cables and equipment other than those specified by our company. Thecorrection will be the responsibility of the user. Use only shielded data cables with thissystem.Intentional emitter per FCC Part 15Low power, Radio LAN type devices (radio frequency (RF) wireless communicationdevices), operating in the 2.4 GHz Band, may be present (embedded) in your notebooksystem. This section is only applicable if these devices are present. Refer to the systemlabel to verify the presence of wireless devices.Wireless devices that may be in your system are only qualified for use in the UnitedStates of America if an FCC ID number is on the system label.The FCC has set a general guideline of 20 cm (8 inches) separation between the deviceand the body, for use of a wireless device near the body (this does not includeextremities). This device should be used more than 20 cm (8 inches) from the bodywhen wireless devices are on. The power output of the wireless device (or devices),which may be embedded in your notebook, is well below the RF exposure limits as setby the FCC.This transmitter must not be collocated or operate in conjunction with any otherantenna or transmitter.Operation of this device is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation of the device.Wireless devices are not user serviceable. Do not modify them in any way.Modification to a wireless device will void the authorization to use it. Contactmanufacturer for service.FCC Statement for Wireless LAN use:“While installing and operating this transmitter and antenna combination theradio frequency exposure limit of 1mW/cm2 may be exceeded at distancesclose to the antenna installed. Therefore, the user must maintain a minimumdistance of 20cm from the antenna at all times. This device can not becolocated with another transmitter and transmitting antenna.”