English - 121. Press the MENU button to display the menu. Press the ▲ or ▼ button to select “Setup”, then press the E button.2. Press the E button again to select “Plug & Play”. For further details on setting up options.The “N Plug & Play” feature is only available in the TV mode.CHANNEL CONTROLCHANNEL CONTROLConfiguring the Channel Menu¦Antenna → Air❑ / CableBefore your television can begin memorizing the availablechannels, you must specify the type of signal source that isconnected to the TV (i.e. an Air or a Cable system).Press theT TOOLS button to display “Tools” menu. You canalso set the Antenna by selecting “Tools → Switch to Cable(or Switch to Air)”.Auto Program❑Air : Air antenna signal. / Cable: Cable antenna signal. / Auto: Air and Cable antenna signalsWhen selecting the Cable TV system: Selects the cable system. STD, HRC and IRC identifyNvarious types of cable TV systems. Contact your local cable company to identify the type of cablesystem that exists in your particular area. At this point the signal source has been selected.After all the available channels are stored, it starts to remove scrambled channels (ClearingNScrambled Channels). The Auto program menu then reappears.If you want to stop Auto Programming, press theN E button. The “Stop Auto Program?”message will be displayed. Select “yes” by pressing the ◄ or ► button, then press the Ebutton.Clearing Scrambled Channels❑ (digital channels only)This function is used to filter out scrambled channels after “Auto Program” is completed. Thisprocess may take up to 20~30 minutes.To stop searching scrambled channels: Press theN E button to select “Stop”. Press the ◄ buttonto select “yes”, then press the button.This function is only available in “N Cable” mode.Channel List❑For the detailed procedures on using the “Channel List”, refer to the ‘Managing Channels’instructions.Fine Tune❑ (analog channels only)Use fine tuning to manually adjust a particular channel for optimal reception.If you do not store the fine-tuned channel in memory, adjustments are not saved.N“*” will appear next to the name of fine-tuned channels.NTo reset the fine tuning setting, press the ▼ button to select “N Reset”, then press the E button.Antenna : Air ►Auto ProgramClear Scrambled ChannelChannel ListFine TuneChannel