English - 4Connecting and Preparing Your TVUsing the Stand-BaseTwo or more people should carry the PDP. Never lay the PDP on thefloor because of possible damage to the screen. Always keep the PDPupright.The PDP can rotate 20 degrees in right and left directions.NNHow to assemble the Stand-Base (depending on the model)Using the 6 screws for securing the stand base and the monitor, firmlyattach the monitor to the stand base.(The exterior of the set may be different than the picture.)In case of installing your TV on the wall, close thecover (1) on the stand-base connection part using twoscrews for hiding.WarningFirmly secure the stand to the TVbefore moving it, as the stand mayfall and could cause serious injury.Two or more people should carry the TV.Never lay the TV on the floor because ofpossible damage to the screen.Always store the TV upright.NChecking PartsOwner’s Instructions Remote Control/AAA BatteriesPower Cord Cloth-Clean Warranty Card/Safety Guide Manual(Not available in all locations)Cover-Bottom / Screws (2ea)(PS50A750)Holder-Ring (4ea)(Refer to page 64)Program CD Ferrite Core for PowerCord (2ea)Ferrite Core (Power Cord)The ferrite core is used to shield the cable from interference. When connecting a cable, open the ferritecore and clip it around the cable near the plug.N-0° ~ 0°