English - 44WISELINK Pro-DLNASetting the DLNA NetworkDLNA allows you to watch videos and pictures saved on your PC on your TV through a network connection in Wiselink Pro mode.This removes the need to copy them to a USB storage device and then connect the device to your TV. To use DLNA, the TV mustbe connected to the network and the DLNA application must be installed on your PC.Network Connections Diagram1 Connect the [LAN] port on the rear panel of the TV to the external modem with a LAN Cable. Connect the PC to which the “DLNA PC Share Manager” programme will be installed and the external modem using a LANcable. Connect the LAN port on the wall and the external modem with a Modem Cable.Connecting to the Network1 When connecting to the network is complete, set up the network on the TV.A Wireless Internet connection does not support DLNA.Three parts(subnet address) before the TV and PC IP addresses should be same. The last part (host address) should bechanged. (e.g. IP Address: 123.456.789.** ) Run a Network Test to check the network settings.Installing the DLNA ApplicationTo play content on the PC on the TV, you have to first install the application.System Requirements1 Insert the Programme CD supplied with this TV into your PC. 20MB of free hard disk space is needed for the programme installation.If you share files, up to 20MB of hard disk drive space is required for each 100 files.If you cancel file sharing, the hard disk drive space used for the thumbnail information is also freed.Supported Formats1 Image: JPEG (jpg, jpeg) Audio: MP3 (mp3) Video: MPEG1(mpg, mpeg), MPEG2 PS/TS(mpg, mpeg, trp, ts, tp), divx(mpg, mpeg, avi), MPEG4/H.264 (mpg, mpeg)NNNNTVExternal Modem(ADSL/VDSL/Cable TV)LANPCLAN1