Samsung SADPCI-202 Instruction Manual

22Installation:LNB:The installation menu provides access to LNB settings and features. These can expand the receiverscapabilities as well as customising the receiver to your preference.Press Menu and select Installation to access the Installation menu:The default LNB setting is as per the diagram above.LNB Power:This toggles the LNB power supply on and off. This option should be set to ON. With the LNB powerswitched off, all control signals for LNB, switches and DiSEqC will also be disabled.LNB A1 to D4:Up to sixteen universal LNBs can be conntected to your digital receiver. For each LNB (A1 to D4) youmay specify the type and control method of the LNB.L.O. Freq:Enter the Local Oscillator Frequency in MHz of your LNB here. For LNBs with two L.O. frequencies,enter the Low Band L.O. frequency in the Low column and the High Band L.O. frequency in the HighColumn. (e.g. For a Universal LNB, the Low Band L.O. frequency is 9750 MHz and the High Band L.O.Frequency is 10600 MHz).Tone:Your digital receiver is equipped with switch controls 12V, 22kHz tone, as well as DiSEqC 1.0DiSEqC:With the DiSEqC options switched on you can select between LNBs from A to D.Note:You may use these controls independently to select different LNBs, and in addition you can use eitherin conjunction with DiSEqC switchs to increase the number of LNBs used. Up to maximum of sixteenLNBs can be used.Note: Universal LNBs uses 22kHz to switch between Low Band and High Band and therefore the22kHz control column is automatically disabled when Univ is selected in the LNB column.Save:Highlight this button and press OK to store any changes made to this menu. If you exit by pressigESC your changes will not be saved.LNB < A1 >LNB Univ HelpLow 09750 MessagesHigh 10600DiSEqC ATone A22k Off12v OffLNB Power On DiSEqC 1.0DiSEqC 1.0 Repeats ToneOFF OFF0Save