8Quick Start:After initialisation, the Language selection screen will be displayed.By using the LEFT/RIGHT keys, you may select thedifferent menu languages available. Once you haveselected the desired menu language, press OK tocontinue with set-up.After selecting the menu language, the receiver will display the Channel Tuning Menu:(Menu, Channel Setup, OK)Preset Entry:Move the cursor to highlight the “Satellite” box anduse the LEFT/RIGHT keys to scroll through the pre-stored satellites. For example, if your dish is aimedat the Astra satellite, when Astra is selected, youshould see both signal meters reading a good signallevel. The receiver will then prompt you to press OKto start tuning to all the channels on Astra.(See next page)Note:1. If you wish to only tune to a specific Network or Bouquet of channels, move the cursor to highlightthe “Bouquet” box and use the LEFT/RIGHT keys to scroll through the pre-stored Bouquets. Youshould now see both signal meters reading a good signal level and the receiver will prompt you topress OK to start tuning all the channels from the selected Network or Bouquet.2. If you only wish to download Free-to-Air channels, high-light the FTA box and turn the option to “on”.Provided your dish is installed correctly and aligned to the relevant satellite, both the Signal and Databars should display a GREEN bar which denotes the following:The first bar shows the actual satellite SIGNAL strengthYou should see a GREEN bar showing your satellite signal is medium to good. If it is RED, thisnormally indicates that either your dish/LNB set-up is not adequate for this satellite, or your dish isnot correctly aligned.The second bar shows the quality of the DATA receivedThis GREEN bar indicates the DATA INTEGRITY of the signal received. If the bar is RED, thisindicates that the DATA received is unreliable. This could cause the picture to break up, ordisappear completely.Note: If “No signal found” is displayed, check that the values entered are correct and are valid forthe satellite your dish is installed for. (Please also refer to the “Advanced Users” and “TroubleShooting” section to check that your LNB settings are correct).Manual Entry (see also “Advanced User Guide” ):(See the “Advanced User Guide” section for more information on manual entry and other tuningoptions other than Auto set-up.)Select Menu LanguageLNBPresetSatelliteFrequencySym. RatePolarityFECA1Setup Satellite1172027500Hor 18v3/4Network Bouquet PIDsFTA OffSignalDataSnaigl FoundUse to change SatelliteF1 – Preset F2 ModeEnglishHotbird – 13.0E