32positioner model:For models fitted with the integrated positioner module, refer to the following instructions for positionersetup (assuming your dish has already been correctly setup):At the back of the receiver you will find eight connectors provided for the dish actuator -M1, M2, SENS, GND:From your actuator motor you will find four wires – two thick and two thin wires. Connect the two thickmotor wires to M1 and M2, the two thin sensor wires to SENS and GND.0/12V, GND:Where applicable, connect a 0/12V LNB switch to these two connectors.+5V, PULSE, GND:Where applicable, connect a mechanical polariser to these three connectors.Positioner setup:With the receiver in analogue mode, press theINFO/POS key to enter the positioner menu:SAT No:Select between 1-64 satellite positions.SAT Name:Displays the satellite name. You may move the cursorinto the name field to edit the satellite name.SAT STORED:When SAT STORED = NO, all channels with the samesatellite name will be assigned to this satellite position.DISH POSITION:Displays the current dish position.EAST LIMIT:You may store the current dish position as the East limitsby moving the cursor here and press STORE.WEST LIMIT:You may store the current dish position as the Westlimits by moving the cursor here and press STORE.REALIGN:If for any reason your dish is out of alignment with thesatellites, use this function to realign all satellites in oneoperation instead of realigning the satellites individually.1. First select a satellite you wish to realign asreference.2. Move the cursor to DISH POSITION3. Move the dish East or West to relocate thereference satellite.4. Move the cursor to REALIGN and press STORE5. Now all other satellite positions will be realignedwith respect to the reference satellite.SAT POSITIONSAT NO 01SAT NAME ARAB 2A,3ASAT STORED NODISH POSI (----) 5000EAST LIMIT 0001WEST LIMIT 9999REALIGN 01CLEAR LIMITSUP/DN, LEFT/RIGHT, OK, ESC