Samsung SADPCI-202 Instruction Manual

303. System MenuLNB INPUT:Select upto eight LNB settings for your analogue system, A1 to A4,B1 to B4. You can assign different LNB parameters (local oscillatorfrequency, LNB power, 22KHz, 12V and DiSEqC control) for eachLNB setting.For the selected input set the following:LOCAL OSC:Select the appropriate LNB local oscillator frequency.You can select from 5.150, 9.750, 10.000, 10.750, 11.000, 11.475,Universal Low Band, Universal High Band, and a variable setting(between 9.100 to 14.000GHz).LNB PWR:Select the LNB power supply. You can select from 14V, 18V andV/H for Marconi type LNBs including Universal LNBs.22KHz:You can select 22KHz ON/OFF to control an external tone switch.Note: When using a Universal LNB, 22KHz will be used to switchthe LNB and therefore 22KHz will be set to AUTO .0/12V:To control an additional 12 volt accessory switch.Decoder:The decoder status; from here you can select the type of decoderde-emphasis required for your decoder.(PAL,MAC,CLAMP,CANAL+)COPY:To copy the settings from exsisting channel’s setting to newChannel’s one directly.4. DiSEqC Menu:SAT POSITION:Use to select between position A or B of a DiSEqC switch.SWITCH OPTION:Use to select between option A or B of a DiSEqC switch.Note:The DiSEqC function is enabled in the Installation menu.DiSEqC:Turns the DiSEqC control function ON or OFF. Switch this optionON when you are using DiSEqC controlled equipment.EPG Key:Pressing the EPG key in analogue mode will display the ChannelLock Menu.Menu Lock:You can set the menu lock NO and YES with this option. Withmenu lock YES, the user must enter a password before any of theprogramming menus are displayed.Channel Lock:To lock the current channel from unauthorised access, enter thepassword to switch the channel lock from NO to YES.(The factory password is 0000. To change the password, see theInstallation menu).Note: the Channel lock is ineffective unless the receiver’s menusare also locked. This prevents the unauthorised user from re-tuning the restricted channel onto a different channel. To enablemenu lock, see the Installation menu.Password:Enter your password for your channel and menu locks. The defaultpassword is 0000.SYSTEM P001LNB INPUT A1LOCAL OSC. UNI-HILNB PWR 14V22KHz OFF0/12V 0VDECODER OFFCOPY 001->001UP/DN, LR, 0-9, OK, ESC, MENDISEQC P001SATPOSITION ASWITCHOPTION 1DISEQC OFFUP/DN, LEFT/RIGHT, OK, ESCCH LOCK P001MENULOCK NOCHLOCK NOPASSWORD 0000UP/DN, LR, 0-9, OK, ESC, MEN