5756Placing a Call using Voice DialingTo place a call using voice dialing:1. Press and hold , or open the phone, depending onthe setting.The phone prompts you to say the name.Waitfor the beep.2. After the beep, say the name into the phone. Say the nameas much like your original recording as possible.u The phone places the call if it recognizes the name.u If the phone does not recognize the name, it prompts forthe name again.u If the phone is unable to recognize the name after twoattempts, the following message displays:“Cannot recog-nize name. Please check name.”.The phone also says “can-not recognize name.”.Then the phone returns to Standbymode and you can try the call again later.Reviewing Voice Dialing EntriesTo review voice dialing entries:1. Press to display the Main Menu.2. Press for Voice Dial.3. Press for Review.A list of entries displays.u Press the digit key to select the desired entry, oru press the scroll keys to select an entry and press .4. The recorded name plays, and if you do nothing, yourentire voice dial list is scrolled and each entry played.When the last entry is played, the phone returns toStandby mode.5. While listening, you can press to return to the VoiceDial menu or to return to Standby mode.ENDCLROKOK2 ABCPQRS7MENUShiftVoice Dialing ActivationVoice dialing is always active once you have programmed thephone to accept voice dialing entries. By default, pressingand holding will activate a voice dial call.You can also initiate a voice dialing call by opening thephone, when you select this option through the Main Menu.To change how a voice dialing call is activated:1. Press to display the Main Menu.2. Press for Voice Dial.3. Press for Set Active.4. Press the scroll keys to toggle between options:u [ ] Only: Enables voice dialing by pressing and holding.u [ ] / Flip: Enables voice dialing by pressing and holding, or by opening the phone.5. When the desired option displays, press to save thesetting.OKOKShiftShiftGHI4PQRS7MENUShiftSCH-N101(eng) 4/6/00 11:53 AM Page 56