Wireless network setup1782. Using a Network-Connected MachineConnecting in PIN mode1 The network configuration report, including PIN, must be printed (see"Printing a network configuration report" on page 158).In ready mode, press and hold the (Stop or Stop/Clear) button onthe control panel for about 5 seconds. You can find your machine’s PIN.2 Press and hold the (WPS) button on the control panel for more than4 seconds until the status LED stays on.The machine starts connecting to the access point (or wireless router).3 You need to enter the eight-digit PIN within two minutes on thecomputer that is connected to the access point (or wireless router).The LED blinks slowly for up to two minutes until you enter the eight-digit PIN.The WPS LED blinks in the order below:a The light blinks fast on the WPS LED. The machine is connecting tothe access point (or wireless router).b When the machine is successfully connected to the wirelessnetwork, the WPS LED light stays on.4 Insert the supplied software CD into your CD-ROM drive, and follow theinstructions in the window to set up the wireless network.Re-connecting to a networkWhen the wireless function is off, the machine automatically tries to re-connectto the access point (or wireless router) with the previously used wirelessconnection settings and address.In the following cases, the machine automatically re-connects to thewireless network:• The machine is turned off and on again.• The access point (or wireless router) is turned off and on again.Canceling the connection processTo cancel the wireless network connection when the machine is connecting tothe wireless network, press and release the (Cancel or Stop/Clear) on thecontrol panel. You need to wait 2 minutes to re-connect to the wirelessnetwork.
