|
Recording settingsHow to set 56English1 Display the screen asexplained in "Displaying the recording settings screen",and then turn the S-dial clockwise. (P39)The "OFF" field of ALARM RECORDING starts blinking.2 Set the alarm recording.1 Turn the J-dial to select ALARM RECORDINGselection, and then turn the S-dial twice clockwise.Selections:OFF/ENABLED/AL-REC ON TIMER/AL-REC OFFTIMER/OLY AL-RC ON TMR2 Turn the J-dial to select the desired PICTUREQUALITY, and then turn the S-dial twice clockwise.After the arrow symbol (=>) the number of alarms thatcan be recorded is displayed.Selections:BASIC/NORMAL/ENHANCED/FINE/SUPER FINEExample:3 Turn the J-dial to switch AUDIO RECORDING "ON",and then turn the S-dial twice clockwise.The letter "A" is displayed in front of the recording rate,and the number of alarms that can be recorded isdisplayed after the "=>" symbol.Example:4 Turn the J-dial to select the recording pattern(ALARM INTERLEAVE), and then turn the S-dial twiceclockwise.Selections: ONLY/SW☞ If ONLY is selected (Figure 1):Live video will be recorded only from the camerawhere the alarm was detected, until the alarm iscancelled.☞ If SW is selected (Figure 2):Live video will be recorded alternately from thecamera where the alarm occurred and from allconnected cameras.5 Turn the J-dial to select the REC RATE (example: 5),and then turn the S-dial clockwise.Repeat the same procedure to set the DURATION.3 Press the EXIT/OSD button.The normal screen is displayed again.• The letter "ALARM" and the number of alarm recordingsare displayed in the operation display.• When an alarm is detected, the "ALARM" field startsblinking.☞ If consecutive alarms are detected on the same channel,depending on the alarm retrigger setting, they may becounted as one alarm. (P60)G-1 Alarm recording settingsMENU(J) (S) REC MODE SET>ALARM RECORDING : OFFPICTURE QUALITY : ENHANCEDAUDIO RECORDING : OFFALARM INTERLEAVE : ONLYREC RATE: 15FPS, DURATION: 20SECPRE-ALARM RECORDING : ***REC RATE: **** FPS, DURATION: ****=> (01731 ALARMS CAN BE RECORDED)ALARM TRIGGER : ALARMMOTION SENSOR ->7.ALARM REC MODE SET2.RECORD SET=> (01387 ALARMS CAN BE RECORDED)REC RATE: A 15FPS, DURATION: 20SEC=> (01431 ALARMS CAN BE RECORDED)1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1Alarm detected Alarm cancelledRecords the channel where the alarm was input until thealarm is turned off1 2 1 3 1 4 1 5 1 6 1 2 1 3 1 4 1 5 1 6Alarm detected Alarm cancelledRecords the channel where the alarmwas input and the other channelsalternately until the alarm is turned offAlarm channelNormal recording02EXIT/OSD01-01-06 00:00:00 REC REPEAT EN A ALARM 0000Alarm totalAlarm indicator
|
