English 233 RECORDINGUse the following procedure to record the monitored videoin the normal recording area.Recording will not be possible until a time has been set forthe digital video recorder. Make sure to set the time.(JP.17)1 Press the [REC/STOP] button.The REC/STOP indicator lights up, “REC” appears on-screen (i.e., the recording symbol), and recording starts.z When recording for the first time, the default settingsare used. For details regarding modification of thepicture quality or recording rate, see P.71.z When the space remaining in the normal recording areadrops below a preset value, the FULL indicator on thedigital video recorder’s front panel starts to flash. Ifrecording is continued beyond this point, the normalrecording area will become full, recording will stop, andthe FULL indicator will stop flashing and remain lit. Insuch a case, use the screen to perform “AREA FULL RESET” for the normalrecording area, thus allowing recording to start againfrom the beginning. (JP.67)z Playback is possible even while recording. See P.26 formore details.2 Press and hold the [REC/STOP] buttonfor approximately 3 seconds.“REC” disappears from the operation display andrecording ends.Use the following procedure to record the monitored videofor a preset length of time in the normal recording area.Recording will not be possible until a time has been set forthe digital video recorder. Make sure to set the time. (JP.17)1 Press the [TIMER] button.The TIMER indicator lights up and the digital videorecorder enters timer recording standby mode.(1) See P.74 for more details on timer recording settings.(2) At the time specified for the start of timer recording, theREC/STOP indicator lights up, “REC” appears on-screen (i.e., the recording symbol), and recording starts.(3) At the time specified for the end of timer recording, theREC/STOP indicator turns off, and recording ends.The [TIMER] button remains lit up.z When the space remaining in the normal recording areadrops below a preset value, the FULL indicator on thedigital video recorder’s front panel starts to flash. Ifrecording is continued beyond this point, the normalrecording area will become full, recording will stop, andthe FULL indicator will stop flashing and remain lit. Insuch a case, use the menuto perform “AREA FULL RESET” for the normalrecording area, thus allowing recording to start againfrom the beginning. (JP.67)z Playback is possible even while recording. See P.26 formore details.2 Press the [TIMER] button.The TIMER indicator turns off and recording ends.CARDCARDMENURESETEJECT[REC/STOP] button [TIMER] buttonFULL indicatorPOWER indicatorNormal recordingEnding normal recording02001-01-04 00:00:00 REC REPEAT EN A ALARM 0000Recording symbolREC/STOPREC/STOPTimer recordingStopping timer recording before completion02001-01-04 00:00:00 REC REPEAT EN A ALARM 0000TIMERTIMERe00_l8hbg_us_7.book Page 23 Thursday, November 25, 2004 1:44 PM
