Sanyo LCD-32K40 Owner's Manual

Also see for LCD-32K40: Service manual

Sanyo LCD-32K40 Owner's Manual Manual pdf 26 page image

26XACTI LINKMake sure that HDMI input is connected to Xacti if Xactibutton is pressed. (The connecting way, please refer to"Connecting to the HDMI terminal" on the INSTRUCTIONSMANUAL(Xacti).) After connecting the Xacti to thetelevision, switch the TV input to the terminal which theXacti is connected.1 Select HDMI SETTING in SETUP menu. Then press ◄►buttons to enter HDMI SETTING menu. ( Figure A.) Select"XACTI LINK ON" by pressing ◄► buttons. ( The detailsfor operation, please refer to "SETUP" on page 38.)2Xacti buttonGREEN(T) buttonRED(W) buttonYELLOW buttonBLUE(MENU) buttonSelect "HDMI-CEC ON " in Xacti menu as Figure B.( For the details, please refer to "TV OUTPUT SETTING"on the INSTRUCTIONS MANUAL(Xacti).)3OFFPress Xacti button to enter DISPLAY mode.(Figure C.)Press ▲▼ buttons to select any picture. Press OK buttonto display selected picture. And you can operate theselected picture by following buttons on Remote Control.(Note: For the details, please refer to INSTRUCTIONSMANUAL(Xacti).)●RED(W) button: Works the same as pushing zoom switchtoward the [W] side.●GREEN(T) button: Works the same as pushing zoom switchtoward the [T]side●YELLOW button: It operates as a preservation button tothe animation edit.●BLUE(MENU) button: Open or close the Xacti menu.4Press Xacti button or RED button to return to the DISPLAYmode.5To exit Xacti mode, select "XACTI LINK OFF" in HDMILINK menu. ( The details for operation, please refer to"SETUP" on page 38.)6Figure B.Figure A.Figure C.OK buttonPOINT ▲/▼/◄/►buttonsThis is a system control function by which, through an HDMI cable, a control signal is output to electronicdevices and the operation of multiple devices is coordinated. The HDMI-CEC function will operatecorrectly only when the Xacti whose model is VPC-HD1010, VPC-HD2000, VPC-FH1, VPC-TH1 orVPC-WH1 is connected to a SANYO TV that incorporates the HDMI-CEC function.Note:● When "XACTI POWER OFF" is set to "ON", the power supplyof Xacti will switch to off if you turn off the television.● When "XACTI POWER ON" is set to "ON", the powersupply of television will switch to on if you turn on the Xacti.● The menu of Xacti will not open when open the televisionmenu.● Message of "Please switch Xacti to the PLAY mode andconnect it." will display on the screen when in the XactiREC mode.● Only SANYO Xacti camera with HDMI-CEC that correspondingto this LCD TV (please refer to SANYO Xacti camera modelwith HDMI-CEC on page 48) .BASIC OPERATIONSETUPXACTI LINK ONXACTI POWER ON OFFXACTI POWER OFF ONHDMI LINKSELECT ADJUST BACK EXIT: : : :REMOTE CONTROLLCD-K40.indd 26 1/21/2010 10:47:22 AM