Sanyo LCD-40XR10SAF Instruction Manual

Memorizing the Channels & Setting the ChannelsWhen you turn on the TV for the first time, you should perform an auto channel scan to set up stations on your TV.Note: Be sure to select the TV input source before operation.Auto Channel Scan You should perform an auto channel scan to search for all channelsavailable and stores them in memory.96.75MHzExitChannel ScanTotal Channel 4To auto scan for channels:1 Go to CHANNEL menu.2 Press 6or 5to highlight Auto Scan, then press ENTER.The TV begins scanning for available channels in your area and storesthem into memory. This may take several minutes, please wait.During the process, you may press EXIT to stop the auto scan, butyou will need to run the auto scan again to set up stations on your TV.Auto/Manual fine tuningTo auto or manual fine tune the programs23 Press 6or 5to highlight Channel Edit, then press ENTER.4 Press 6or 5to highlight FineTune, then use 3or4to manuallyfine tune until the best possible picture and sound are achieved.Or you can turn AFC function to ON to automatically fine tune theprogram.In Channel Edit sub-menu, highlight AFC and press 4, use 6or 5to select ON and then press ENTER.If you perform manual fine tuning, the AFC function will be turned offautomatically.51 Select a channel you want to perform fine tuning.0CHANNELSkip ChannelFineTuneAFCFav CHOFFOFFOFFMove Adjust ReturnFine Tuning is not necessary under normal conditions. However, in areaof inferior broadcast conditions where adjustment is necessary for abetter picture and sound, use fine tuning (auto or manual fine tuning) .Go to CHANNEL menu.6 To return to previous menu, press MENU. To close the menu, pressEXIT button.Setting the AIR/CABLE optionTo set the AIR/CABLE option:1 Press MENU. The on-screen menu opens.Press 6or 5to display CHANNEL menu, then press ENTER.2Before your TV can memorize the available channels, you must specifythe type of signal source that is connected to the unit. (i.e., an antenna orcable system)Highlight AIR/CABLE, then press ENTER.3Press 6or 5to select AIR or CABLE, then press ENTER.Select CABLE if using Cable TV, select AIR if using VHF/UHF antenna.4To exit, press EXIT button.5MTSAuto ScanChannel EditAIR/CABLE CABLEMONOCHANNELMove EnterMTSAuto ScanChannel EditAIR/CABLE CABLEMONOCHANNELMove OKMTSAuto ScanChannel EditAIR/CABLE CABLEMONOCHANNELMove Enter14AIRCABLEReturnReturnReturnColor System AUTOColor System AUTOColor System AUTO