Sanyo LCD-40XR10SAF Instruction Manual

Identification of Controls5Main Unit (front view)Main Unit (back view)12435 6 7 8 9 10 11 12HDMI 2HDMI 1 PC INRFS-VIDEORS-232AUDIODVI AV OUTAV1 INYL RAUDIOC /Pr rC /Pb bCOMPONENT INVGAVIDEO L RAUDIOVIDEO L RAUDIO1. USB port: Connect a USB device to this port.2. Headphone: Connect headphones to this jack.3. AV2 INPUT: Connect an AV device to these jacks.4. AC IN: Plug the AC cord into this jack and into a poweroutlet.5. HDMI1/2: Connect an HDMI device to this jack.6. PC IN VGA/AUDIO: Connect a computer to these jacks.7. COMPONENT IN: Connect a component video device tothese jacks.8. AV1 INPUT: Connect an AV device to these jacks.9. AV OUTPUT: Connect a VCR to these jacks to recordprograms.10. RF: Connect an antenna or cable TV tothis jack.11. S-VIDEO IN: Connect an S-Videodevice to this jack, then connect an audiocable to the AV1 IN AUDIO jacks.12. RS-232: For service only. Do not use.7VIDEO L RAUDIOAV2 IN USBNote: Buttons on the TV control panel are touchsensors. First touch of the button will illuminate it.Second touch will fulfill its function. Be sure buttonpresses must be quickly done before theillumination disappears and it is suggested totouch the sensor center, otherwise theoperation may not fulfill successfully.1 2INPUT MENU CH VOL +3 4 5 6 7INPUT MENU CH VOL1. Remote sensor2. Power indicatorLights blue when in operating mode.Lights red when in standby mode.3. POWER4. INPUTTo access Input menu5. MENUPress this button to access the main menu screen.6. CHPress these two buttons to directly change the TV channel;In menu operations, these buttons serve as up/down buttons.7. VOL+Press the VOL+ or VOL– button to directly increase ordecrease the sound volume level;In menu operations, these buttons serve as right/left buttons.Receives signals from the remote control.Do not block.Press this button to turn the unit ON from STANDBY mode.Press it again to turn the set back to STANDBY.^/^/–