Sanyo LCD-40XR10SAF Instruction Manual

Adjusting the PictureAdjusting the picture To adjust the picture:1Press 6or 5to highlight an option, press 3or4to adjust theoption; If a sub-menu exits, press ENTER to access the option, thenpress 3465to operate and press ENTER to confirm. You canselect:25 To close the menu, press EXIT button.Press MENU. The on-screen menu opens with the VIDEO menudisplayed, then press ENTER to access.! Picture Mode — Selects the picture mode. You can select:. Vivid (a bright and vivid picture). Standard (a standard picture). Gentle (a soft picture). User (user customized picture).Note: You can also press PICTURE on the remote control to selectthe picture mode.! Contrast — Adjusts the contrast.! Brightness — Adjusts the brightness.! Color — Adjusts the color saturation.! Sharpness — Adjusts the sharpness.! Hue — Adjusts the image tint(only for NTSC system).To adjust advanced video settings, in VIDEO menu press 6or 5tohighlight Advanced, press ENTER to access the sub-menu.3Press 6or 5to highlight an option, press ENTER to access theoption. Press 6or 5to select the setting and press ENTER toconfirm, or press 3or4to adjust the option. You can select:4! Color Temp — Selects the color temperature. You can selectWarm (to enhance the reds), Cool (to enhance the blues), orNormal.!picture noise (snow). You can select Low, Middle, High, or OFF.Noise Reduction — Selects the noise reduction mode to reduce! Display Mode — Selects the aspect ratio of the picture. You canselect:. 4:3 — Shows picture in 4:3 display mode.. 16:9 — Shows a full-screen picture in 16:9 mode.. Zoom1 — Enlarges the picture vertically. The top and bottommay be cropped.. Zoom2 — Enlarges the picture both horizontally and vertically.The edges may be cropped.. Panorama — Stretches the picture at the edges, but maintains agood aspect ratio at the center of the screen.Note: You can also press ZOOM on the remote control repeatedlyto select the display mode.Freezing the picture Press the FREEZE button to freeze the image on the screen (the videosources still run). Press again to restore.Note:! If a fixed image is displayed on the screen for a long time, that fixedimage may become imprinted on the screen and remain visible.Therefore do not freeze the picture for a long time.! In some mode, the FREEZE function can not work.To freeze the picture:Noise ReductionDisplay ModeColor Temp NormalMiddle16:9VIDEOMove Enter ReturnMoveVIDEOOKContrastBrightnessSharpnessColorHueAdvancedPicture Mode User5050496061VividStandardGentleUserMoveVIDEOEnterContrastBrightnessSharpnessColorHueAdvancedPicture Mode User4949496261ReturnReturnMoveVIDEOEnterContrastBrightnessSharpnessColorHueAdvancedPicture Mode User4949496261ReturnOver Scan ON! Over Scan — Turns this ON to adjust the picture’s reproductionrate when receiving HDMI signal in VIDEO format.(Depending onversions, in some model this function is not available)16