Sanyo PLC-EF60 Owner's Manual

Also see for PLC-EF60: Specifications Service manual

Contents

16PreparationThis wireless remote control uses radio frequency signal. You can switch four frequency channels prepared and select aremote control ID from eight IDs. The Remote Control Channel selection prevents radio frequency interference from theother equipment and the Remote Control ID selection allows you to operate several projectors with their respective remotecontrols without mutual interference among those projectors.Wired Remote Control TransmitterThe remote control can be used as a wired remote control. Wheninterference between the projector and other equipment occurs orthe projector is used in a place where the operation of radioequipment is restricted, connect the remote control and theprojector with the remote control cable provided. Connected withthe remote control cable, the remote control does not emit radiosignal.Remote Control Channel and ID SetupInitial Remote Control Channel and ID are CH1 and ID1. Whenyou change the setting, set a Channel first, and then an ID.Channel and ID settings for the remote control should be thesame as those for the projector. When changing the CH and IDsettings to the remote control, do it to the projector as well. Referto "Remote Control " in Setting menu on page 53.Should you be lost at which CH and ID are currently set, initializethe Channel and ID once, and set them again.With holding down the CH button, press the SELECT button.The Remote Control Channel switches sequentially for onepressing the SELECT button. (See Table1 on next page.)With holding down the CH and ID buttons together, slide theREMOTE RESET/ON/ALL-OFF switch to REMOTE RESET,and then to ON. The initial Channel and ID are CH1 and ID1.(p15)1MENUMENUC A N C E LINFO AUTO PCSCREENFREEZEP-TIMERSOUNDREMOTEVOL.MUTECHIDINPUT 4INPUT 1INPUT 2INPUT 3INPUT 5REMOTE RESET ON ALL OFFL E N S S H I F TK E Y S T O N ES H U T T E R D . Z O O MZ O O M F O C U SO N - O F FWhile pressing the CH/IDbutton, press the SELECTbutton number of timescorresponding to theremote control CH/ID.MENUC A N C E LINFO AUTO PCSCREENFREEZEP-TIMERSOUNDREMOTEVOL.MUTECHIDL E N S S H I F TK E Y S T O N ES H U T T E R D . Z O O MZ O O M F O C U SO N - O F FID buttonCH buttonSELECT button✔Note:Remote Control Channel and ID cannot be initialized separately.Set the Remote Control ChannelSet the Remote Control ID2With holding down the ID button, press the SELECT button.The Remote Control ID switches sequentially for onepressing the SELECT button. (See Table2 on next page.)Initialize the Remote Control Channel and IDRemote Control Transmitter