Sanyo PLC PLC-XP100BKL Owner's Manual

Contents

Sanyo PLC PLC-XP100BKL Owner's Manual Manual pdf 59 page image

59Turn off the projector and unplug the AC power cord. Letthe projector cool for at least 45 minutes.Loosen the screw and open the lamp cover. Pull out thelamp by using the built in handle.13Replace the lamp with a new one. Make sure that thelamp is properly and fully inserted.4Open the filter cover. (p.57)2Connect the AC power cord to the projector and turn onthe projector.6Follow these steps to replace the lamp.Reset the Lamp counter (p.60)5✔Note:• Be sure to insert the lamp in the correct direction.• Do not reset the Lamp counter when the projection lamp isnot replaced.Lamp ReplacementFor continued safety, replace with a lamp of thesame type. Do not drop the lamp or touch theglass bulb! The glass can shatter and may causeinjury.Allow a projector to cool for at least 45 minutesbefore you open the lamp cover. The inside of theprojector can become very hot.CAUTION CAUTIONWhen the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on thescreen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timingwhen the LAMP REPLACE indicator should light is depending on the lamp mode.Top PanelLAMP REPLACE indicatorLamp replacement icon✔Note:• The Lamp replacement icon will not appear whenthe Display function is set to “Off” (p.48), during“Freeze” (p.28), or “No show” (p.29).7Close the lamp cover and secure the screw.LampHandleLamp coverFilter coverScrewMaintenance and Care8Close the filter cover.