78Serial Control InterfaceAppendixThis projector provides a function to control and monitor the projector's operations by using the RS-232C serialport.Connect a RS-232C serial cross cable to CONTROLPORT on the projector and serial port on the PC.(See p.20)Launch a communication software provided with PCand setup the communication condition as follows:123Baud rate : 9600 / 19200 bpsParity check : noneStop bit : 1Flow control : noneData bit : 8Type the command for controlling the projector andthen enter the "Enter" key.ExampleWhen you want to change the input to INPUT 2, Type'C' '0' '6' 'Enter'.✔Note:• Enter with ASCII 64-byte capital characters and one-byte characters.✔Note:• The default of the baud rate is set to 19200 bps. If anerror occurs in the communication, change the serialport and the communication speed (baud rate).Operation
