Sanyo PLC-SW35 Owner's Manual

Contents

48Maintenance and CleaningWhen the life of the projection lamp of this projector draws to anend, the LAMP REPLACE indicator lights yellow. If this indicatorlights yellow, replace the lamp with a new one promptly.Follow these steps to replace the lamp.LampLamp CoverORDER REPLACEMENT LAMPReplacement lamp can be ordered through your dealer. When ordering a projection lamp, give the followinginformation to the dealer.● Model No. of your projector : PLC-SW35● Replacement Lamp Type No. : POA-LMP91(Service Parts No.610 321 3804 )For continued safety, replace with a lamp of the sametype. Do not drop a lamp or touch a glass bulb! Theglass can shatter and may cause injury.Allow a projector to cool, for at least 45 minutes beforeyou open the Lamp cover. The inside of the projectorcan become very hot.POWER LAMPREPLACEWARNINGThis indicator lights yellowwhen the life of the projectionlamp draws to an end.Top ControlCAUTIONScrewScrewTurn off the projector and disconnect the AC plug. Allow theprojector to cool for at least 45 minutes.Loosen 2 screws of the lamp with a screwdriver and pull outthe lamp by grasping the handle.13Replace the lamp with a new one and tighten the 2 screwsback into position. Make sure that the lamp is set properly.Replace the lamp cover and tighten the screw.4Loosen the screw with a screwdriver, and remove the lampcover.2Connect the AC power cord to the projector and turn on theprojector.6 Reset the Lamp replace counter.See “Lamp Replace Counter” on the next page .5Lamp ReplacementHandleScrewCAUTION