10PREPARATIONPICTURE LEVEL AND TILT ADJUSTMENTPicture tilt and projection angle can be adjusted withhandles on both sides of the projector. Projection anglecan be adjusted to 5.7 degrees upper way.123MOVING THE PROJECTORCAUTION IN CARRYING OR TRANSPORTING THE PROJECTOR Do not drop or bump the projector, otherwise damages or malfunctions may result. When carrying the projector, use a suitable carrying case. Do not transport the projector by using a courier or transport service in an unsuitable transport case. Thismay cause damage to the projector. To transport the projector through a courier or transport service,consult your dealer and best case should be applied.For safety, be sure to hold Carrying Handleson both sides by 2 or more people whenmoving the projector. Moving it unproperlymay result in damage of cabinet or person'sinjury.Replace the lens cover and retract the feet toprevent damage to the lens and cabinet.123Pull up the lock buttons on each side of carryinghandles and release the locks.CARRYINGHANDLELOCK BUTTONSPull carrying handles out fully until it's locked (with aclick). Move the projector by holding two handles by 2 ormore people.To retract carrying handles, pull up the lock buttons andrelease the lock of handles and press the handles fullyin until it's locked.LEVEL AND TILTADJUST HANDLEADJUSTABLEFEETThe height of front feet can beadjusted by turning the handles.KNOBPress the knob on the handle. The handle pop out.Turn the handles (right and left) until the picture isprojected on proper position. Adjust height of rearadjustable feet by rotating them until projector properlystabled on the table.Press knob and retract the handle.REAR ADJUSTABLEFEET. (Refer to P7).Pull up the lock buttonsto release the lock.