Sanyo PLC-XF47 Owner's Manual

Also see for PLC-XF47: Brochure Specifications Owner's manual Service manual

Contents

57Maintenance and CareCheck the number of lamp to be replaced on the LampStatus Display.Remove the two screws on the Lamp Cover and pressthe button to open the Lamp Cover. (See the right figure.)13Loosen two screws and pull out the Lamp to be replacedby grasping handle.4Turn off the projector and unplug the AC Power Cord. Letthe projector cool for at least 45 minutes.2Replace the Lamp with a new one and tighten twoscrews. Make sure the Lamp is set properly.6Follow these steps to replace the lamp.Put the Lamp Cover back and tighten two screws.578Connect the AC Power Cord to the projector and turn onthe projector.Reset the Lamp Replacement Counter. (Refer to section"Resetting the Lamp Counter" on page 58.)NOTE : Do not reset LAMP REPLACEMENT COUNTER whenlamp is not replaced.BUTTONSCREWSLAMPCOVERSCREWSMake sure which number of lamp needs to bereplaced on Lamp Status Display.Figure shows case of replacing LAMP 2.LAMP 1LAMP 2LAMP 3LAMP 4CAUTION : DO NOT OPERATE A PROjECTOR WHILE ANy OF LAMPS IS REMOVED IT MAy RESULT INMALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTSNOTES ON LAMP REPLACEMENTTo maintain quality of picture (better balance of color and brightness in entire screen), werecommend replacing all 4 lamps at a timeLamp ReplacementFor continued safety, replace with a lamp assemblyof the same type.Do not drop the lamp assembly or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool, for at least 45 minutesbefore you open Lamp Cover. The inside of aprojector can become very hot.CAUTIONTURN OFF THE UV LAMP BEFOREOPENING THE LAMP COVER.WARNING:When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on thescreen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timingwhen the LAMP REPLACE indicator should light is depending on the lamp mode.IndicatorsLAMP REPLACE indicatorLamp replacement iconREADY✔Note:• The Lamp replacement icon will not appear whenthe Display function is set to “Off” (p.47), during“Freeze” (p.28), or “No show” (p.29).Downloaded From projector-manual.com Sanyo Manuals