Sanyo PLC-XK2200 Owner's Manual

Also see for PLC-XK2200: Owner's manual User manual Owner's manual Manual Manual

Contents

63$SSHQGL[ 3UREOHP – SolutionsNo power – Plug the power cord of the projector into the AC outlet.– See if the POWER indicator lights red.– Wait until the POWER indicator stops blinking to turn on theprojector again. The projector can be turned on after thePOWER indicator turns red. See page 18.– Check the WARNING indicator. If the WARNING indicator lightsred, projector cannot be turned on. See page 58.– Check the projection lamp. See page 61.– Unlock the Key lock function for the projector. See page 53.7KHLQLWLDOGLVSOD\LVQRWVKRZQ– Make sure 2II or &RXQWGRZQRII are not chosen at displayfunction. See page 46.7KHLQLWLDOGLVSOD\LVQRWVDPH– Make sure 8VHU or 2II are not chosen at Logo (select)DVWKHGHIDXOWVHWfunction. See page 46.,QSXWVLJQDOVZLWFKHVDXWRPDWLFDOO\– Make sure Input search function is adjusted properly.RUGRHVQRWVZLWFKDXWRPDWLFDOO\ See page 45.:KHQWKHSURMHFWRULVRQDQG – That is the Filter warning icon. See page 56.\RXSUHVVWKHLQSXWVRXUFHEXWWRQVDQLFRQRWKHUWKDQWKH/DPSPRGHLFRQDSSHDUV.$QLFRQRWKHUWKDQ,QSXWPRGH – That is the Lamp replacement icon or the Filter warning icon.or Lamp mode icon appears. See page 61 or 56.,PDJHLVRXWRIIRFXV – Adjust focus of the projector. See page 23.– Provide proper distance between the projector and theprojection screen. See page 13.– Check the projection lens to see if it needs cleaning.See page 60.– Moving the projector from a cool to warm place may result inmoisture condensation on the projection lens. In such cases,leave the projector off and wait until condensation evaporates.,PDJHLV/HIW5LJKWUHYHUVHG – Check the Ceiling/Rear function. See pages 35,43.,PDJHLV7RS%RWWRPUHYHUVHG – Check the Ceiling function. See pages 35,43.3LFWXUHLVQRWEULJKWHQRXJK – Check if the Contrast or %ULJKWQHVV is adjusted properly.See pages 33, 40.– Check if ,PDJHPRGH is selected properly. See pages 32, 39.– Check the lamp control function. See pages 25, 52.– Check the LAMP REPLACE indicator. If it lights, the end of lamplife is approaching. Replace the lamp with a new one promptly.See page 61.7URXEOHVKRRWLQJBefore calling your dealer or service center for assistance, check the items below once again.– Make sure you have properly connected the projector to peripheral equipment as described onpages 14-16.– Make sure all equipment is connected to AC outlet and the power is turned on.– When the projector does not project an image from the connected computer, restart the computer.